Envision H819 Instructions d'exploitation

Downloaded from ManualMonitor.com Manuals

9 FRONT PANEL CONTROL • Power Button: Press this button to switch ON/OFF of monitor’s power. • MENU / ENTER : Activate OSD menu when OSD is OFF

10 HOW TO ADJUST A SETTING 1. Press the MENU-button to activate the OSD window. 2. Press ▲ or ▼ to navigate through the functions. Once the des

11 ADJUSTING THE PICTURE The descriptions for function control LEDS Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Icon Description Lumina

12 Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Icon Description Color Boost Full Enhance On/Off Disable or Enable Full Enhance Mode Natu

13 Main Menu Item Main Menu Icon Sub Menu Item Sub Menu Icon Description OSD Setup H.Position Adjust the horizontal position of OSD V.Position A

14 PLUG AND PLAY Plug & Play DDC 2B Feature This monitor is equipped with VESA DDC 2B capabilities according to the VESA DDC STANDARD. It allow

15 TECHNICAL SUPPORT (FAQ) Problem & Question Possible Solution Power LED is not on *Check if the Power Switch is in the ON position *Power Cor

16 ERROR MESSAGE & POSSIBLE SOLUTION CABLE NOT CONNECTED : 1. Check that the signal-cable is properly connected , If the connector is loose

17 APPENDIX SPECIFICATIONS LCD Panel Driving system 18.5” TFT Color LCD Viewable Image Size 470mm diagonal Pixel pitch 0.3mm( H ) × 0.3mm( V ) In

18 External Controls: Switch • Auto Adjust Key • ECO Adjust Key/DCR shortcut key • 16:9/4:3 shortcut key • Power Button • MENU Functions • Lum

1 TABLE OF CONTENTS FOR YOUR SAFETY -------------------------------------------------- 1 SAFETY

19 Preset Display Modes STANDARD RESOLUTION HORIZONTAL FREQUENCY VERTICAL FREQUENCY VGA 640 x 480 @60Hz 31.469 59.940 VGA 640 x 480 @67Hz 35.00

20 156101115 15 - Pin Color Display Signal Cable PIN NO. DESCRIPTION PIN NO. DESCRIPTION 1. Red 9. +5V 2. Green 10. Detect Cable 3. Blue 11. G

21 ISO 14001 Certification ISO 14001 certification is the pattern of certification of the environmental management system, is the core standard of I

2 Fu. Before operating the monitor, please read this manual thoroughly. This manual should be retained for future reference. FCC Class B Radio Freq

3 PRECAUTIONS  Do not use the monitor near water, e.g. near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 

4 SPECIAL NOTES ON LCD MONITORS The following symptoms are normal with LCD monitor and do not indicate a problem. NOTES • Due to the nature of t

5 INSTALLATION INSTRUCTIONS SWIVEL BASE Install Remove Figure 1 Installing and Removing

6 CONTROLS AND CONNECTORS VIDEO CABLE Connecting the D-Sub Cable: Connect one end of the 15-pin D-Sub cable to the back of the monitor and conn

7 ADJUSTING THE VIEWING ANGLE • For optimal viewing it is recommended to look at the full face of the monitor, then adjust the monitor’s angle to y

8 OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS Press the power button to turn the monitor on or off. The other control buttons are located at fro